4-Pack 39" Cable Protector Ramp | 18,000 Lb Capacity Speed Bump | Indoor & Outdoor

Cables and hoses running across a floor — in a garage, at an event, on a job site — are a trip hazard and a liability until they're protected.

The Fredlox Direct 39" Cable Protector Ramp gives you a 4-pack of industrial-grade rubber ramps built to cover and protect floor cables, power cords, hoses, and wiring in high-traffic areas. Each ramp is 39.37" long with a 1.18 x 0.79" channel groove that accommodates most standard cables and hoses, and the 18,000 lb/axle load rating means vehicles can drive over them without damage. The high-visibility yellow stripe and anti-slip texture keep pedestrians aware and the ramp in place, and mounting holes let you anchor them to the ground permanently when needed. Connect multiple ramps to cover any run length.

Why You'll Love It

• 18,000 lb/axle vehicle load rating — cars, trucks, and forklifts can drive over without crushing cables or damaging the ramp
• 1.18 x 0.79" channel groove — wide enough to route electrical cables, power cords, air hoses, and water hoses
• 4 ramps per pack, 39.37" each — connect end-to-end for continuous protection across longer cable runs
• High-visibility yellow stripe — alerts pedestrians and drivers to the ramp so they slow down and step over carefully
• Anti-slip texture keeps ramp in place — stays put under foot traffic without sliding or shifting out of position
• Industrial rubber — waterproof, wear-resistant, low-odor — rated to −40°F for indoor and outdoor use in any weather
• Mounting holes for permanent installation — use expansion screws to anchor ramps to concrete or asphalt when you need them fixed in place

Specifications

What's Included

• 4× 39" industrial rubber cable protector ramps

Every pack ships quality-inspected and ready to install. Not satisfied? Our return policy keeps your purchase completely risk-free.

Add to cart and protect your cables — and everyone walking over them.